Step up to a NEW Barber-Colman MODEL 3504 CONTROLLER
We understand what it takes to replace one controller with another. That's why we supply you with the following tools and functionality.
| What is the
SAFEST way to replace your Barber-Colman MODEL 560 or 570 CONTROLLER?
Step up to a NEW Barber-Colman MODEL 3504 CONTROLLER |
|
| Barber-Colman
makes it easy for you to upgrade your system by replacing your aging model 560
or 570 controller. The new model 3504 easily replaces the 560 and 570
programmer. Check out the link below for a 560 to 3504 part number conversion
program.
We understand what it takes to replace one controller with another. That's why we supply you with the following tools and functionality. |
| To upgrade to the new Barber-Colman controller takes just 3 easy steps - just follow the instructions below and you are on your way. |
| 1) Ready - |
Locate the existing Barber-Colman 560 or 570
controller. The exact part number is on the side of the instrument case and
another copy of the part number is on the top lip of the controller if you have
already removed it from the case. Inspect the rear terminal wiring of the
Barber-Colman 560. It probably has:
|
| 2) Set- |
|
You can mount the 3504 controller in a new hole, make a cover plate that converts the larger 6 inch by 6 inch cut out to the newer 1/4 DIN cutout. E-Mail us about availability of a converter plate. Then, if you follow our easy to use wiring diagrams, reconnect your existing wires and you have a permanent installation. We can also supply an adapter housing so the new 3504 slides right into the existing housing so you don't need to touch any wires. This is great for rapid replacements of one or two instruments If you are using the 560 digital interface, we can supply the traditional 560 or 570 protocol. Just reconnect the wires to the new 3504, set the address and baud rate and watch the communications take off. The 3504 can have a plug-in board installed (either now or later) that permits it to communicate using Modbus RTU. A factory developed Modbus RTU OPC server is available for OPC interfaces to visualization software. |
| 3) GO- |
| The link below will take you to our easy part number cross reference tool. If your part number is not listed call or send an e-mail for our expert advice. In addition, you may wish to consider additional features and we can assist you with those too. |
Click Here To Go to Part Number Cross Reference Tool |
| THE 3504 DOES NOT REQUIRE A MEMORY LOADER |
| Technical Support |
| Barber-Colman expert advice is available at
controlsupport@eurotherm.com
or by calling our factory at 703-669-1313. We also have a strong team of
professionally trained distributors and direct sales managers located
throughout North America who can also assist you.
If you have any other questions or would like the name of the nearest distributor contact our sales office at 703-669-1312 or e-mail info@eurotherm.com. |
| Last Updated Wednesday, June 10, 2009 |
