| Version 2.30 -- Adds the OEM Security (special
EU0725) and the Comms Watchdog features. Bug fixes include:
improvements to the Flash write for GWE layout and wires; Commstab
lockup; CT parameters saved in clone files; 4-20mA output in
Standby; Loop inhibited after Program runs.
iTools version V6.52.2
or later will support this version - for earlier releases, the
IDM and
Help file should be installed as above. |
|
V2.30 English (2,868KB)
Firmware |
Version 2.10 of this software is compatible with all Mini8™ instruments and iTools V6.44 or greater
but requires installation of V2.10 IDM (Instrument Descriptor
Module) in iTools as described below.
Please read the
InstallInstructions file for installation requirements and instructions. |
|
V2.10 English (2,864KB)
Firmware |
IDM Install instructions
To perform the upgrade after iTools V6.44 has been installed.
- Copy the V2.10 IDM and the V2.10 Help file to c:\Program
Files\Eurotherm\iTools\Devices directory on the PC where iTools
is installed
- On the PC select Start->All Programs->Eurotherm->iTools
Advanced->IDM Manager if the PC is running XP or
Start->Programs->Eurotherm->iTools Advanced->IDM Manager if the
PC is running Windows 2000 or NT
- When the program starts click on the "Install New IDM"
button, browse for the file named ID_MINI8_V210.exe, select it
and press the open button
- You will be asked if you would like to copy this file to
another location, this is not required since you have already
saved the file to the correct location. Click "No"
- Installation is now complete
|
| V2.10
IDM for iTools (1,160KB)
and
Help file (480KB) |
|
Version 2.02 of this software is compatible with all Mini8™ instruments and iTools V6.40 or greater.
Please read the readme.txt file for installation requirements and instructions. |
|
V2.02 English (2,865KB) |
| V1.20 English (2,749KB) |
